Kia Owners Club Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello,

I have a 2008 Kia Cee'd SR-7... my wife's car, been fantastic as a cheap run around.

It had a seized slider pin on the front left, which has wore one side of the pad down to the wear pin. I managed to get the slider out after much penetrating fluid and attacks with an impact gun and hammer/chisel. Will replace with a Frentech rebuild kit all round.

My question...

What is the required torque that attaches the caliper bracket to the knuckle (pn# 581512E000)?
What is the require torque for the slider pin bolt (pn#: 581631G000)?

Cheers!

 

·
Registered
Joined
·
552 Posts
From the Service Manual I have

Caliper guide rod bolt 21.6 ~ 31.4 Nm
Caliper mounting bolt (Front) 78.5 ~ 98.1 Nm
Caliper mounting bolt (Rear) 49.0 ~ 58.8 Nm


 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
From the Service Manual I have

Caliper guide rod bolt 21.6 ~ 31.4 Nm
Caliper mounting bolt (Front) 78.5 ~ 98.1 Nm
Caliper mounting bolt (Rear) 49.0 ~ 58.8 Nm


Thank you!

Unfortunately I also took out the ABS sensor on the front right. So now have to wait for one of those. Hope the error clears by itself and not require an OBD diagnostics clear.
 
1 - 3 of 3 Posts
Top