Kia Owners Club Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 · (Edited)
Is the outer bodywork area of the tailgate, (2018 Sportage GT Line), where the number plate fits plastic or metal?

It seems to be plastic with a metal panel behind it, I just need to check before I fit new plates.

T.I.A.(y)
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
It's a combination of both. Rear door bottom panel, up to the handle/number plate light, is plastic, above that is metal. There should be locator holes where the number plate attaches to.
Cheers for that. Long story short I need to temporarily fit some plates, but I can't use the existing holes and didn't want to drill new ones into a metal panel, but if it's plastic I don't mind too much.

You can see it's had a couple of sets of holes drilled in already so I'm guessing it should be fine?
Automotive tire Road surface Rectangle Grey Asphalt
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top