Kia Owners Club Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
Hello all,

Has anyone ever experienced the very rear seats not sliding in there rails evenly?

It would seem that only one runner isdisengaging and then the seat twists and gets stuck


I spent about 2 hours trying to free the seat and then re-fit it on Sunday for it to twist and bind again the next day


Any easy solution to this????

Many thanks
 

·
Registered
Joined
·
43 Posts
Hi had the same issue, runners get full of crap, hoover them out, WD40 them, then you should be able to push the top of the runner down to release it (square plastic button).
Slid the runners up and down a few times to ensure they are free.
make sure the runners are lined up, level with each other, replace the seat, again ensure that both front latches engage.
if you dont get both sides in properly, this will cause the seat to twist as one of the runners will not release when you lift the seat handle.
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #3 ·
Found out that my problem was a spring had become un clipped from one of the big rear latches. Stretched the little bleeder back on and hay presto seat runs like a well oiled machine.;-)
 
1 - 3 of 3 Posts
Top