Kia Owners Club Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi al I am a new one on forum just fitted replacement engine into my 2004 second 2.9 crdi last week .this was after head gasket failure and a bad experience with a replacement cylinder head to which I bit the bullet and opted for engine swap .I found the replacement engine not a bad unit till today where I am getting a knocking noise on load at about 1500 rpm to 2700rpm then all sound ok .checked oil pressure that seems fine .any ideas anybody? Rob
Edited by: rabbie41
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
Hi Mike I have a complete engine Bar rocker shafts and rocker cover .the bottom half of engine is in perfect condition having only covered 70k as for the head it was skimmed and fitted only to find the camshafts need machined for the head I have two injectors in working order the common diesel rail is there aswell along with cam cogs etc .
 

·
Registered
Joined
·
68 Posts
hi rabbie, thank you for the reply,today i dropped lucky and found some injectors very local so tonight all fitted ,up and running ,so thanks anyway but i will remember what you have ,cheers mike.
 
1 - 4 of 4 Posts
Top