Kia Owners Club Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
hi all again , i want to change the fuel filter on my 2003 sedona 2.9 diesel, can anyone please tell me how to do please , does it have to go to a garage and can i buy one on ebay , an item number on ebay would be great if possible

thankyou all

leighton
 

·
Registered
Joined
·
887 Posts
5 mins!
Unclip 3 pipes, squeeze square part together push down a little then pull of.
Undo 2 x 12mm bolts holding filter housing to body.
Lift whole assmebly up, reach down and unplg water sensor
Loosen bolt clamping unit to filter.
Remove filter and spill diesel everywhere.
Drain of remaining diesel, and unscrew water sensor.
Put water sensor in new filter, do not screw to tight as it will split the seal, just nip it tight.
Refit in reverse.
Once fitted prime using pump bulb until hard, start engine, if it stalls keep priming.
160348057622

anything else?
 

·
Registered
Joined
·
6 Posts
I know this is an old thread but hoping to get answers

Kia Sedona 2.9 CRDI

recently water sedimenter warning light came on the dash and I decided to replace the whole filter as it looked abit old.

New filter in all good and light gone away and few miles later light came back again.

drained put back together and light actually comes back within 30 seconds.

What would be my next step ??
 
1 - 4 of 4 Posts
Top